During Operation Function - Application; Cycle Time; Objects Sends Cyclic - ABB i-bus KNX Product Manual

11.3.4

During operation function - Application

Options:
Inactive:
■
– Application is not active.
Object during operation:
■
– Application is active.
The application makes monitoring of the device possible. A 1-bit telegram for further evaluation
is made cyclically available to the KNX bus via communication object "HB: output". This, for
example, allows monitoring of the device on a visualization. When the device is removed, it
does not send a cyclic telegram and a fault message appears on the visualization.
The following communication object is available:
"HB: output"
■
Note
The following parameters can only be adjusted when the function "Function
during operation" is set on "Object during operation".
The parameters for application "Function during operation" can be called up via
general parameters .
11.3.4.1

Cycle time

Options:
The telegrams of the object during operation are sent cyclic on the bus.
The parameter specifies the time interval from which a new sending of the telegrams occurs.
11.3.4.2

Objects sends cyclic

Options:
ON telegram:
■
– Object during operation sends an On telegram.
Off telegram:
■
– Object during operation sends an Off telegram.
The parameter is used to specify whether an Off or an On telegram is sent cyclic on the KNX
bus via communication object "HB: output" during the parameterized time.
Product manual 2CKA001473B9482
Description of application and parameters
Inactive
Object during operation
Setting option from 00:00:55 to 01:30:00 (hh:mm:ss)
On telegram
Off telegram
Application "Device settings"
│64