Setup And Function; Configurable Devices - ABB i-bus KNX Product Manual

4

Setup and function

The device is designed for decentralised flush-mounted installation.
■
The device can be linked with an available actuator via KNX group addresses.
■
The device (with bus coupler) can be assigned to an available switch actuator.
■
The integrated bus coupler makes possible the connection to the KNX bus line.
■
The device can, for example, send switching, dimming or blind control commands to KNX
■
actuators. The device can also be used for storing and sending of light scenes.
The device has an internal temperature sensor for measuring the actual temperature in the
■
room. The measured value is made available to the KNX bus via communication object.
The device must be parameterized for the use of the functions.
■
The sensor is integrated in the flush-mounted insert and already pre-mounted.
■
Additional product features:
LEDs as light for orientation / status indication
■
4.1

Configurable devices

The devices can be configured prior to delivery. The following sectors, for example, can be
configured according to requirement.
Button icons
■
Colour of the buttons
■
Additional text for the buttons
■
Number of buttons (up to the maximum possible for the respective size of glass plate)
■
Alignment of buttons (if the glass plates are not square)
■
Alignment of the glass plates (if the glass plates are not square)
■
The function of the respective buttons is parameterised via the ETS4.
Alternative to the configurable models, the preconfigured versions are available.
The configuration is carried out with the tacteo configurator at tacteo-configurator.my.busch-
jaeger.de
Note
Due to the options for configuration, your device no doubt differentiates itself
from the examples shown here.
The type of operation, however, is carried out in the same way.
Note
Configured devices are excluded from replacement or a reimbursement.
Product manual 2CKA001473B9482
Setup and function
│15