Samsung DCS Programming Manual page 381

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
Dial Parameter
28 SIP SERVER
PORT
29
SIGNAL PORT Sets the IP UDP port number for signalling.
32
SEND CLIP
TABLE
33 INCOMING
MODE
34 ALLOW GW
CHECK
ACTION
1. Open programming and select 837
Display shows
2. Dial option number 00–34
OR
Press VOLUME keys to select and press RIGHT
soft key
3. Enter parameter value or press VOLUME keys to
select, as required
4. Press Transfer/TRSF to store and exit
OR
Press SPEAKER to store and advance to next
MMC
Default Data: See table above.
Related Items: None
Description
Sets the port number of the SIP Server.
Sets the table number programmed in
as caller information when calling through the VoIP network. If set
as 'None' the number programmed in
For VoIP incoming calls, sets whether to use the received called
party number, or to follow
specified for each C.O. line in
Allows Gateway IP check.
MMC 837 (Page 2 of 2 )
MMC 323
MMC 405 is used.
MMC 714, or to use the destination
MMC 406.
DISPLAY
GATEWAY CALL ID
1234
GATEWAY CALL ID
1234
MMC PROGRAMS
FEBRUARY 2004
Default
05060
10000
that will be sent 1
Follow DID
Trans
DISABLE