Group Type - Samsung DCS Programming Manual

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 601
FOR:
Purpose: Assigns stations to groups. This provides more flexibility, for example, if using
Uniform Call Distribution (UCD), AA GROUP and VM/AA applications. A station, com-
mon bell, and ring page can be in more than one group, but must all be the same ring
type. The maximum members per group for each system is as shown in the table.
Max members
per group
Note: A device for announcement, if used, must provide a hookflash and return the call to the
group.
The options to program depend on your system, but will be some or all of the following:
G T , R
ROUP YPE ING
H , G B
UNT ROUP USY

GROUP TYPE

NORMAL GROUP
VMAA GROUP
UCD GROUP
AA GROUP
CADENCE or
BI-VMS
MSG
S0
Other possible entries are:
3801–3820 COM. BELL
3601–3640 RING PAGE
ASSIGN STATION GROUP
ALL SYSTEMS
DCS CI CII 816
48 30 30 16
M , O
ODE VERFLOW
and
GROUP AUTO ANSWER
Station ring group
Group VMAA ports designated in
ute or sequential ringing (see
UCD group—has wrap-up capability. See
AA group—can only have distribute or sequential ringing (see below)
Voice Mail group (VM card must be installed in system). Can only
have distribute or sequential ringing (see
Used to group a number of extensions to serve as a message desk
or message group. When one of the stations in the group leaves a
message for another station, the messaged station will reply to the
message group so any member can answer the call (iDCS500 and
OS500 systems only)
Allows S ports to be members of a station group. Valid members
0
are MSN numbers assigned to the S
This device is a common bell relay on a Trunk A card.
This device is ring over an external page zone output of
a Trunk A card.
MMC 601 (Page 1 of 3)
408/408i iDCS100
8 32
, G T , N
ROUP RANSFER
.
MMC 207—can only have distrib-
Ring Modes, below)
Ring
bus.
0
MMC PROGRAMS
FEBRUARY 2004
iDCS500 OS500
48
P , M
EXT ORT EMBER
UCD Groups, below.
Modes, below)
48
, N
EXT