Samsung DCS Programming Manual page 373

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
OS500 MGI Card & Procedure
GATEWAY CALL ID
H.323 FAST SETUP
CALLER ID TYPE
TUNNELING
DEFAULT DIL NO.
CODEC AUTO NEGO
SIGNAL PORT
SEND CLIP TABLE
INCOMING MODE
ALLOW GW CHECK
ACTION
1. Open programming and select 834
Display shows
2. Press VOLUME keys to select option (e.g. H.323
FAST SETUP) and press RIGHT soft key
3. Press VOLUME keys to select ENABLE/DISABLE
press RIGHT soft key
4. Press Transfer/TRSF to store and exit
OR
Press SPEAKER to store and advance to next
MMC
Default Data:
DEFAULT DIL NO: 5000 (OR 500)
CODEC AUTO NEGO: OFF
SIGNAL PORT: 10000
SEND CLIP TABLE: 1
Related Items:
A numeric entry that identifies the system via the MGI connection.
Maximum entry is four digits.
Enables or disables the H.323 Fast Start call method.
This option controls the calling party identification type. The type is
identical to that sent by the caller to be displayed.
Sets whether to use the Q.931 signalling channel for H.245 signal-
ling instead of using a separate channel.
Sets the call forward number for incoming calls that does not
include the dial digit.
Sets whether to automatically change the CODEC to be used according to
the other party.
Sets the IP port number for H.323 signalling.
Sets the Caller Data Table number in
the caller information when calling through the VoIP network.
Number in
For VoIP incoming calls, sets whether to use the received Called
Party Number as is, or to follow
tion specified for each C.O. line in
Enables Gateway IP check.
GATEWAY CALL ID: 1234
H.323 FAST SETUP: DISABLE
CALLER ID TYPE: ANI
TUNNELING: DISABLE
INCOMING MODE: FOLLOW DID TRANS
ALLOW GW CHECK: DISABLE
VoIP MMCs
MMC 834 (Page 3 of 4)
MMC 405 is used when set as None.
MMC
DISPLAY
GATEWAY CALL ID
1234
H.323 FAST SETUP
ENABLE
H.323 FAST SETUP
DISABLE
MMC PROGRAMS
FEBRUARY 2004
MMC 323 that will be sent as
714, or to use the destina-
MMC 406.