Opening System Or Customer Level Programming; Opening Station Level Programming; Programming Dcs-408 And 408I Systems - Samsung DCS Programming Manual

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
1.6.2 Opening System or Customer Level
Programming
To open programming:
1. Press the Transfer / TRSF key.
2. Enter the MMC program number 200 (for Customer level programming) or 800 (for
System level programming).
3. Enter the relevant passcode.
4. Press key 1 (or use the VOLUME keys) to select 'ENABLE'.
5. Press the SPEAKER key to have the program selection mode appear (or press the
Transfer / TRSF key to halt programming).
6. Enter the MMC number, or select the program number with the VOLUME keys and
press the SPEAKER key.
When you have opened system programming, you are advised to check
lect Country) to ensure that the correct country has been selected before you do any
other programming.
Carefully follow the instructions given with each selected MMC to program your system
correctly.

1.6.3 Opening Station Level Programming

To open programming:
1. Press the Transfer / TRSF key.
2. Enter the MMC program number.
You can use the MMCs described in this manual as a guide, although it is advisable to
refer to the Samsung keyset or phone user guide provided with your keyset/phone to
program it correctly.

1.6.4 Programming DCS-408 and 408i Systems

Although the 408 is physically similar to the 408i in appearance, they operate differently
and may have different programming requirements and features. For example, the 408i
supports ISDN whereas the 408 does not. Thus, an MMC relevant to one system may
not be relevant to the other. Similarly, where an MMC relates to both systems, some fea-
tures available on the 408i system may not be available on the 408 system, and vice
versa. This will be indicated in the MMC description, where appropriate.
These systems also differ significantly from all other telephone systems, both in size and
physical appearance. Remember, when programming your 408 or 408i:
•
Extension, group and trunk numbers are two digits by default (e.g. extension 21,
trunk 71, etc). Other systems use 3- or 4- digit numbers by default (e.g. extension
201, trunk 701, etc). These numbering plans may be changed using
•
You can set up to four 'Normal' station groups in
not permitted.
•
Only two trunk groups, 8 and 9, are available.
MMC
1–7
INTRODUCTION
FEBRUARY 2004
MMC 812 (Se-
MMC 724.
601. Other group types are