Samsung DCS Programming Manual page 274

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 722
FOR:
Purpose: Customises programmable keys on individual keysets and add-on modules
(AOMs). All systems are provided with default functions for some keys to provide basic
operation. For example, keys 1 and 2 are set as CALL keys by default because it is rec-
ommended that these keys should always function as CALL keys. A keyset will not oper-
ate correctly unless it has at least one CALL key programmed (but see note, below).
Other keys can be programmed as described here. You can use the VOLUME keys to
scroll through the selectable functions when programming keys (see table at the end of
this MMC).
Functions can also be entered via the dial keypad. For example, to assign the OHVA
function, key number 6 can be pressed three times. If the BOSS function is required,
press 2 twice for the first letter B, and then use the VOLUME keys to change the selec-
tion from BARGE to BOSS.
Note: 408/408i systems do not support AOMs and default key functions are different from other
systems. For example, keys 1 and 2 are not set as CALL keys by default as these are not re-
quired.
ACTION
1. Open programming and select 722
Display shows
OR
For 408/408i systems, display shows
(The programming procedure is, however, the
same)
2. Enter station number (e.g., 205)
OR
Press VOLUME keys to make selection and press
RIGHT soft key
3. If you have a 408/408i system, or if the selected
station has no AOM pair, go to step 4
Enter 0 for MAST, 1 for AOM1 or 2 for AOM2.
OR
Press VOLUME keys to make selection and press
RIGHT soft key
4. Enter key number (e.g., 18)
OR
Press VOLUME keys to make selection and press
RIGHT soft key
OR
Press a programmable key
STATION KEY PROGRAMMING
ALL SYSTEMS
MMC 722 (Page 1 of 4)
MMC PROGRAMS
FEBRUARY 2004
DISPLAY
[201] KEY (MAST)
01:CALL1 →
OR
[21] KEY PROG
01:DT71 →
[205] KEY (MAST)
01:CALL1 →
[205] KEY (MAST)
01:CALL1 →
[205] KEY (MAST)
18:NONE →_