Grooming Reel Bearing Replacement - Toro Greensmaster 3150 Service Manual

Grooming Reel Bearing Replacement

16
9
10
Seal lip
(toward center of
cutting unit)
(toward center of
RIGHT
FRONT
1. Pivot hub
2. Spacer
3. Idler bracket
4. Spacer
5. Drive plate (cutting unit LH side)
6. O- -ring
NOTE: The groomer reel drive is located on the left side
of the cutting unit, opposite from the hydraulic cutting
reel motor.
Bearing Removal
1. Remove the cutting unit from the machine and place
cutting unit on a flat work area.
2. Remove front roller, grooming reel and drive plate
assembly from left side of cutting unit (see Grooming
Reel Removal in this section).
Groomer
15
8
10
9
Seal lip
cutting unit)
7. Retaining ring
8. Grease fitting
9. Bearing
10. Seal
11. Idler pulley
6
7
5
9
10
Seal lip
(toward center of
cutting unit)
Figure 10
3. Remove groomer support plate assembly from the
right side of cutting unit:
A. Remove two (2) socket head screws and lock
nuts that secure motor mount to cutting unit (Fig. 11).
Remove motor mount from cutting unit.
B. Remove lock nut and spring washer that secure
RH groomer arm lift rod to support plate (Fig. 12). Re-
move support plate from cutting unit.
Page 8 - - 12
4
3
11
13
14
12
12. Lock nut
13. Bearing
14. Retaining ring
15. Support plate (cutting unit RH side)
16. Plug
Greensmaster 3150
2
1