Suzuki 2006 SX4 Service Manual page 80

1A-36 Engine General Information and Diagnosis:
DTC No. Detecting item
Crankshaft Position
*P0335 (CKP) Sensor "A" Circuit
Camshaft Position (CMP)
*P0340 Sensor "A" Circuit
Catalyst System
Efficiency below
* P0420
Threshold
Evaporative Emission
System Purge Control
*P0443
Valve Circuit
Fuel Level Sensor "A"
P0462 Circuit Low
Fuel Level Sensor "A"
P0463 Circuit High
Fan 1 Control Circuit
*P0480
Fan 2 Control Circuit
*P0481
Vehicle Speed Sensor "A"
*P0500 (VSS)
Brake Switch "A"/"B"
P0504 Correlation
A/C Refrigerant Pressure
P0532 Sensor "A" Circuit Low
A/C Refrigerant Pressure
P0533 Sensor "A" Circuit High
Internal Control Module
*P0601 Memory Check Sum Error
Control Module
P0602 Programming Error
Control Module
*P0607 Performance
Starter Relay Circuit Low
* P0616
Starter Relay Circuit High Starter switch signal is detected for 180 sec.
*P0617
Detecting condition
(DTC will set when detecting:)
CKP sensor signal is not detected for 2 sec. even though
starter is operated.
If either of the following condition is fulfilled:
• CMP sensor pulse is lower than 20 pulses per
crankshaft 8 revolutions.
• CMP sensor pulse is higher than 28 pulses per
crankshaft 8 revolutions.
• CMP sensor pulse is lower than 20 pulses per
crankshaft 8 revolutions from engine start.
Ratio of integrated value of HO2S output variation per
integrated value of A/F sensor output variation is more
than specification while vehicle is running after warmed
up.
• Monitor signal of EVAP canister purge valve is not
varied for 5 sec. even though EVAP canister purge
valve control duty is between 10% and 90%.
• Monitor signal of EVAP canister purge valve is lower
than specified voltage for 5 sec. even though EVAP
canister purge valve control duty is 0%.
Circuit voltage of fuel level sensor is lower than 0.11 V for
5 sec. with engine running.
Circuit voltage of fuel level sensor is lower than 4.77 V for
more than 5 sec. with engine running.
Monitor signal of radiator cooling fan relay No.1 is lower
than specified voltage for 5 sec. even though radiator
cooling fan relay No.1 is OFF.
Monitor signal of A/C condenser cooling fan relay is lower
than specified voltage for 5 sec. even though A/C switch
is ON and A/C condenser fan is OFF.
• Vehicle speed signal is lower than 2 km/h (1.2 mph) for
4 sec. while fuel shuts off at deceleration below 3,600
rpm.
• Vehicle speed signal is lower than 2 km/h (1.2 mph) for
4 sec. even though engine is running at D-Range with
more than 3,600 rpm (A/T model).
If either of the following condition is fulfilled:
• Brake pedal switch signal (ON) and brake light switch
signal (ON) are detected at a time.
• Brake pedal switch signal (OFF) and brake light switch
signal (OFF) are detected at a time.
Output voltage of A/C refrigerant pressure sensor is lower
than 0.2 V for 5 sec.
Output voltage of A/C refrigerant pressure sensor is
higher than 4.93 V for 5 sec.
Data write error or check sum error.
Data programming error
ECM internal processor error.
Starter switch signal is not detected even though engine
speed is 500 rpm or more.
DTC MIL
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
2 driving 2 driving
cycles cycles
2 driving 2 driving
cycles cycles
1 driving Not
cycle applicable
1 driving Not
cycle applicable
1 driving 1 driving
cycle cycle
2 driving 2 driving
cycles cycles
2 driving 2 driving
cycles cycles
1 driving Not
cycle applicable
1 driving Not
cycle applicable
1 driving Not
cycle applicable
1 driving 1 driving
cycle cycle
1 driving Not
cycle applicable
1 driving 1 driving
cycle cycle
2 driving 2 driving
cycles cycles
2 driving 2 driving
cycles cycles