Suzuki 2006 SX4 Service Manual page 704

5A-116 Automatic Transmission/Transaxle:
3) Using special tool and hydraulic press (2), compress
underdrive clutch piston return spring (1) until spring
seat is pushed down to 1 – 2 mm (0.039 – 0.078 in.)
lower than snap ring groove and remove snap ring
(3).
Special tool
(A): 09926–98350
CAUTION
!
Be careful when applying pressure, for
overpressure will cause plate section of
underdrive clutch piston return spring to
deform.
4) Remove underdrive clutch piston return spring (1).
1
3
5) For removing underdrive clutch piston (1), install
6) Remove underdrive clutch piston with O-rings by
2
(A)
I4RH01510143-01
Reassembly
1) After applying A/T fluid to new O-rings and install O-
2) Install underdrive clutch piston (2) to underdrive
underdrive clutch drum to transaxle case (2).
applying compressed air (400 – 800 kPa, 4 – 8 kg/
cm 2 , 57 – 113 psi) from through oil hole (3).
NOTE
If piston does not pop out, it is recommended
to use needle-nose pliers from removal.
2
rings (1) to underdrive clutch piston (2).
clutch drum (3) by pushing with fingers.
NOTE
Do not twist or deviate O-rings during
installation.
1
1
1
3
I5RH01510018-01
2
3
I4RH01510145-01