Suzuki 2006 SX4 Service Manual page 722

5A-134 Automatic Transmission/Transaxle:
32) Apply A/T fluid to new O-rings and install O-rings to
1st / reverse brake piston (1).
33) Place 1st / reverse brake piston (1) into transaxle
case.
NOTE
Do not twist or deviate O-rings during
installation.
1
34) Mount 1st / reverse brake piston return spring (1).
35) Install retainer ring (2) by compressing 1st / reverse
brake piston return spring (1) with flat end rod or the
like.
NOTE
Make sure that opening end of ring is not
aligned with protrusion of transaxle case.
36) Apply petroleum jelly to front planetary ring gear
front thrust bearing race (3).
37) Place front planetary ring gear front thrust bearing
race (3) onto counter driven gear.
I4RH01510212-01
3
1
2
I4RH01510213-01
38) Apply petroleum jelly to front planetary ring gear
front thrust bearing (1) and front planetary ring gear
rear thrust bearing (2).
39) Install front planetary ring gear front thrust bearing
(1) and front planetary ring gear rear thrust bearing
(2) to front planetary ring gear (3).
40) Install front planetary ring gear (3).
2
1
41) Make sure that front planetary ring gear (1) turns
freely when turned counterclockwise [A] and locks
when clockwise [B].
[A]
1
42) Install separator plates "S", friction plates "F" and
retaining plates "R" in the following order.
R → F → S → F → S → F → S → F → S → F → R
43) Install snap ring, using flat end rod or the like.
NOTE
Make sure that opening end of ring is not
aligned with protrusion of transaxle case.
3
I4RH01510214-01
[B]
I4RH01510215-01
R
F
S
R
I4RH01510216-01