Suzuki 2006 SX4 Service Manual page 303

5) Screw new filter on oil filter stand by hand until the
filter O-ring contacts mounting surface.
CAUTION
!
To tighten oil filter properly, it is important to
accurately identify the position at which filter
O-ring first contacts mounting surface.
6) Tighten the filter (1) 3/4 turn from the point of contact
with the mounting surface using an oil filter wrench
(2).
Tightening torque
Oil filter (a): 14 N⋅m (1.4 kgf-m, 10.5 lb-ft) for
reference
3/4
2
7) Replenish oil until oil level is brought to FULL level
mark on dipstick (oil pan and oil filter capacity). The
filler inlet is at the top of the cylinder head cover.
NOTE
Engine oil capacity is specified as the
following.
However, note that the amount of oil required
when actually changing oil may somewhat
differ from the data depending on various
conditions (temperature, viscosity, etc.).
Engine oil specification
Oil pan capacity: About 4.3 liters (9.1 / 7.6 US /
lmp pt.)
Oil filter capacity: About 0.2 liter (0.4 / 0.3 US /
lmp pt.)
Others: About 0.3 liter (0.6 / 0.5 US / lmp pt.)
Total: About 4.8 liters (10.1 / 8.4 US / lmp pt.)
1, (a)
I5JB0A020021-01
Engine Lubrication System:
8) Check oil filter and drain plug for oil leakage.
9) Start engine and run it for 3 minutes. Stop it and wait
another 5 minutes before checking oil level. Add oil,
as necessary, to bring oil level to FULL level mark (1)
on dipstick.
2. Low level mark (hole)
1E-4
IYSQ01020012-01