Gear Shift Control Lever And Cable Removal And Installation; Gear Select Control Cable Adjustment - Suzuki 2006 SX4 Service Manual

5B-10 Manual Transmission/Transaxle:
Gear Shift Control Lever and Cable Removal
and Installation
Removal
1) Remove console box.
2) Disconnect cable ends (5) from pivot (6) of gear shift
control lever assembly by removing clip.
3) Disconnect gear shift and select control cables (1)
from gear shift control lever assembly (2) while
pulling quick joint (4) as shown in figure.
4) Remove gear shift control lever assembly mounting
nuts (3) and gear shift lever assembly from floor
panel.
5) Disconnect gear shift and select control cables from
transaxle.
6) Remove cable grommet bolt, and then remove gear
shift and select control cables from floor panel.
3
4
1
Installation
Reverse removal procedure for installation nothing the
following.
• Tighten each bolts and nuts to specified torque
referring to "Gear Shift Control Lever and Cable
Components".
• Adjust gear select control cable referring to "Gear
Select Control Cable Adjustment".
S6RW0C5206005
2
3
6
5
I4RS0A520003-01

Gear Select Control Cable Adjustment

1) Release lock plate (1) which restricts moving of
cable end holder (2).
2) Push cable end holder (2) out from adjuster (4) using
appropriate tool (3) to disengage cable.
3) Apply grease to pin (5) of gear shift control lever, and
then install adjuster (1) into pin of gear shift control
lever securely.
"A": Grease 99000–25011 (SUZUKI Super
Grease A)
4) Push cable end holder (2) in the direction of A.
NOTE
At this time, do not apply force in the cable
operation direction B to adjuster.
S6RW0C5206006
I4RS0A520004-01