Repair Instructions; Engine Oil And Filter Change - Suzuki 2006 SX4 Service Manual

1E-3 Engine Lubrication System:

Engine Oil and Filter Change

WARNING
!
• New and used engine oil can be
hazardous.
Be sure to read "WARNING" in "General
Precautions in Section 00" and observe
what is written there.
• Step 1) – 7) outlined below must be
performed with ENGINE NOT RUNNING.
For Step 8), be sure to have adequate
ventilation while engine is running.
Use only engine oil of SG, SH, SJ, SL or SM grade.
Select the appropriate oil viscosity according to the chart
[A].
It is highly recommended to use SAE 5W-30 oil.
However, SAE 10W-30 oil is usable for ambient
temperatures above – 18 °C (0 °F).
[A]
o
C -30 -20 -10
o
F -22 -4
14

Repair Instructions

S6RW0C1506008
20W-40, 20W-50
15W-40, 15W-50
10W-40, 10W-50
10W-30
5W-30
0 10 20 30 40
32 50 68 86 104
I4RS0A020002-01
Before draining engine oil, check engine for oil leakage.
If any evidence of leakage is found, make sure to correct
defective part before proceeding to the following work.
1) Remove right side engine under cover.
2) Drain engine oil by removing drain plug.
3) After draining oil, wipe drain plug clean. Reinstall
drain plug.
Tightening torque
Engine oil drain plug (a): 35 N·m (3.5 kgf-m, 25.5
lb-ft)
4) Loosen oil filter by using oil filter wrench (special
tool).
Special tool
(A): 09915–40611
(A)
NOTE
Before fitting new oil filter, be sure to oil its
O-ring. Use engine oil for this purpose.
I5JB0A020020-01
IYSQ01020009-01