Suzuki 2006 SX4 Service Manual page 651

Reference waveform No. 1
Signal of pressure control solenoid valve.
Measurement
CH1: "C06-4" to "C06-2"
terminal
Oscilloscope CH1: 5 V/DIV
setting TIME: 2 ms/DIV
Measurement Engine running at specified idle
condition speed after warmed up engine.
Reference waveform No. 2
Signal of TCC pressure control solenoid valve.
Measurement
CH1: "C06-5" to "C06-1"
terminal
Oscilloscope CH1: 10 V/DIV
setting TIME: 10 ms/DIV
Measurement Drive vehicle at 60 km/h (37 mile/h)
condition or higher after warmed up engine.
Reference waveform No. 3
High and low of CAN communication signals.
Measurement
terminal
Oscilloscope
setting
Measurement
condition
I7RW01510019-01
1. CAN communication line signal (high)
2. CAN communication line signal (low)
Reference waveform No. 4
Signal of output shaft speed sensor.
Measurement
terminal
Oscilloscope
setting
Measurement
condition
I7RW01510020-01
Automatic Transmission/Transaxle:
CH1: "C06-7" to "C06-1"
CH2: "C06-17" to "C06-1"
CH1: 1 V/DIV, CH2: 1 V/DIV
TIME: 40 µs/DIV
Ignition switch is at ON position.
CH1: "C07-5" to "C06-1"
CH1: 2 V/DIV
TIME: 4 ms/DIV
Drive vehicle at 40 km/h (25 mile/h)
after warmed up engine.
5A-63
I7RW01510021-01
I7RW01510022-01