Suzuki 2006 SX4 Service Manual page 785

Clutch Cover and Clutch Disc Inspection
Clutch Disc
Measure depth of rivet head depression, i.e. distance
between rivet head and facing surface.
If depression is found to have reached service limit at
any of rivet holes (2), replace clutch disc assembly (1).
Rivet head depth
Standard: 1.65 – 2.25 mm (0.06 – 0.09 in.)
Limit: 0.5 mm (0.02 in.)
Tightening Torque Specifications
Fastening part
Clutch bleeder plug
CPP switch lock nut
Clutch master cylinder nut
Clutch operating cylinder assembly mounting
bolt
Clutch fluid pipe flare nut
Flywheel bolt
Clutch cover bolt
NOTE
The specified tightening torque is also described in the following.
"Clutch Cover, Clutch Disc and Flywheel Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
Clutch Cover
S6RW0C5306013
1) Check diaphragm spring (1) for abnormal wear or
damage.
2) Inspect pressure plate (2) for wear or heat spots.
3) If abnormality is found, replace clutch cover.
Do not disassemble it into diaphragm spring and
pressure plate.
I4RS0A530019-01
Specifications
Tightening torque
N⋅m kgf-m
5
7.5
13
10
16
70
23
lb-ft
0.5 4.0
0.75 5.5
1.3 9.5
1.0 7.5
1.6 11.5
7.0 51.0
2.3 17.0
Clutch: 5C-11
I3RM0A530015-01
S6RW0C5307001
Note