Front Disc Brake Caliper Inspection; Front Brake Disc Removal And Installation - Suzuki 2006 SX4 Service Manual

5) To confirm that boot is fitted in its groove in cylinder
properly, pull piston out of cylinder a little but do not
take it all out.
NOTE
Boot's face (1) should be at the same level
from cylinder's face (2) all around.
6) Insert piston into cylinder by hand.

Front Disc Brake Caliper Inspection

Pin Boot and Cylinder Boot
Check boots for breakage, crack and damage.
If defective, replace boots.
Piston Seal
Excessive or uneven wear of pad lining may indicate
unsmooth return of piston.
In such case, replace rubber seal.

Front Brake Disc Removal and Installation

CAUTION
!
During removal, be careful not to damage
brake flexible hose and not to depress brake
pedal.
Removal
1) Hoist vehicle and remove front wheel.
2) Remove caliper assembly by removing caliper
carrier bolts (2 pcs).
NOTE
Hang removed caliper with a wire hook or the
like so as to prevent brake hose from
bending and twisting excessively or being
pulled.
I4RS0A420004-01
S6RW0C4206007
3) Pull brake disc off by using 8 mm bolts (1) (2 pcs).
I2RH01420014-01
I2RH01420015-01
Front Brakes: 4B-6
S6RW0C4206008
I4RS0B420010-01
I5RW0A420003-01