Steering Hanger Beam Replacement - Honda 2004 Odyssey Service Manual

Dashboard

Steering Hanger Beam Replacement

NOTE:
• Have an assistant help you when removing and
installing the steering hanger beam.
• Take care not to scratch the dashboard.
• Put on gloves to protect your hands.
1. Remove the dashboard (see page 20-73).
2. Remove the following parts from the dashboard:
• Instrument panel (see page 20-69)
• Gauge assembly (see page 22-100)
• Center lower console (see page 20-68)
• Audio unit (see page 22-159)
• Display unit (with navigation system) (see page
22-385)
3. From under the dashboard on the driver's side,
remove the nut, and pull out the fuse/relay box (A).
Fastener Location
: Nut, 1
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
A
20-76
4. Open the driver's side door, and remove the
dashboard side cover (A).
–1 Remove the screw.
–2 Gently pull out along the rear edge to release
the clips (B, C).
–3 Gently pry out on the side cover to release the
clips (B) and the tabs (D), then remove the side
cover.
Fastener Locations
: Srew, 1 B : Clip, 4
D
A
D
C : Clip, 3
B
C
B
C
B
C
B