HIKVISION DS-2CD883F-E Installation Manual page 109

108
Installation Manual of Network Camera
Figure 4-46 Drill on the Surface
Make sure the drilling hole is big enough for the camera lens.
2. Remove a side of the adhesive tape on the bracket. Paste the bracket on the mounting surface
with aligning with the drilling hole. As shown in Figure 4-47.
Figure 4-47 Paste the Bracket
3. Install the Block-shaped sensor unit into the bracket and make it to be buckled.
4. Tighten the fastening screw on the top of the bracket.
Lo-Call 1890 866 900 www.cctvireland.ie shop@cctvireland.ie