Removing Auto Louver Motors - Hitachi RCI-1.0FSN3 Service Manual

10 Servicing

10.1.12 Removing Auto Louver Motors

1 Remove the air panel according to the item "Removing Optional Air Panel".
2 Remove the fixing screws for each corner cover and remove the corner covers.
3 Remove the packings and guides.
4 Remove two (2) fixing screws for each motor from the air panel.
Remove the screw for louver bearing, and pull it out from the air panel. Then, remove the louvers, louver bearings and
motors.
5 Remove the motors from the louvers.
6 Remove each connector connected to the motors.
N O T E
• When reassembling, securely catch the C-shaped part of louver spring onto the hooking part of
louver. Additionally, insert the L-shaped part of louver spring into the hole of louver bearing.
• Rotate the louver bearing 360o clockwise before fixing the screw for louver bearing.
Packing
Fixing Screw
Guide
Motor
for Auto Louver
Reassembling
314
SMGB0077 rev.0 - 01/2013
Packing
Guide
Corner Cover
Air Panel
Louver Bearing
Louver
Hooking Part
Louver Bearing
Louver
Hole
Spring
Fixing Screws
for Auto Louver
Connector
Louver Spring
Louver Bearing
Louver
Bearing
Louver
Air Panel
Motor
for Auto Louver
Rotate 360
o
clockwise.