Functions Of The Dip Switches And Rsw Switches - Hitachi RCI-1.0FSN3 Service Manual

4 Electrical wiring
• DX-Interface
PCB1

4.2.2 Functions of the DIP switches and RSW switches

C A U T I O N
Turn off the power supply before setting the DIP switches. If not, the settings will not be valid.
N O T E
• The symbol "■" indicates the position of the DIP switches. The figures show the setting before transmission
or after selection.
• If the "■" mark is not displayed, this indicates that the position of the pin is not affected.
DSW2 switch: optional functions setting (only for RPK-FSN(H)3M)
C A U T I O N
Do not set the DSW2 switch, as it is factory-set prior to delivery.
Factory setting
Setting for indoor units installed side by side when wireless remo-
te control switch is used..
DSW3 switch: capacity code setting
This is used to set the capacity code corresponding to the power of the indoor unit.
C A U T I O N
Do not set the DSW3 switch, as it is factory-set prior to delivery.
HP
Setting position
160
SMGB0077 rev.0 - 01/2013
RPK-(0.8-4.0)FSN(H)3M
0.8 1.0
PCB2
1.3 1.5