List Of Optional Remote Control Functions - Hitachi RCI-1.0FSN3 Service Manual

6 Optional functions
Selection of another indoor unit
In optional function setting mode, press TEMP ▲ or TEMP ▼ on the remote control to select the indoor unit on which the
optional function is to be set.

6.3.2 List of optional remote control functions

Element Optional function
Removal of heating
b1
temperature compensation
Circulator function at heating
b2
Thermo- OFF
Forced compressor operation
b3
for at least three minutes
Pre-determined filter cleaning
b4
period change
Fixing of operation mode
b5
Fixing of setting temperature
b6
Fixing of cooling operation
b7
Automatic COOL/HEAT
b8
operation
Fixing of fan speed
b9
Not available
bA
224
SMGB0077 rev.0 - 01/2013
Individual
Settings Condition setting
setting
Standard setting.
00 It increase the
temperature +4ºC
O
01 Removal
It increase the
02
temperature +2ºC
Not activated
00
function
O
01 Activated function
Not activated
00
function
O
01 Activated function
00
01
O 02
03
04
Not activated
00
function
X
01 Activated function
Not activated
00
function
X
01 Activated function
Not activated
00
function
X
01 Activated function
Not activated
00
function
X
01 Activated function
Not activated
00
function
X
01 Activated function
"- -"
X
permanent
This function is used when the
temperature setting displayed on the
remote control and the supply air
temperature of the indoor unit must be
the same.
.
(1)
This function means that the unit
fan remains running after the air
conditioning system has stopped
to prevent the air in the room from
stratifying.
This function is used to protect the
compressor, preventing it from being
started or stopped for periods of less
than three minutes.
Standard
100 hours
This function is used to modify the
1200 hours period which the remote control
indicates the air filter replacement.
2500 hours
Not used
Once the unit operating mode has
been selected, this function prevents
it from being modified from the remote
remote control.
Once the unit temperature has been
selected, this function prevents it
from being modified from the remote
control.
This function is available to use
cooling mode only and to prevent
heating mode from being enabled.
This function allows the automatic
change from the cooling to the heating
mode for the units with the same
refrigerant cycle.
Once the unit fan speed has been
selected, this function prevents it
from being modified from the remote
control.
Not available –
Description