Air Panel Installation - Hitachi RCI-1.0FSN3 Service Manual

2 Unit installation

2.1.4 Air panel installation

Check the indoor unit height from the false ceiling surface
Check the distance between the indoor unit and the false ceiling. It is 12+5mm as shown below.
If not, adjust the distance by using the checking scale with maintaining the levelness of the indoor unit.
Removing Air Intake Grille from Air Panel.
1 Push both ends of knobs at the air inlet grille toward the arrow direction, open the air inlet grille until the angle of
approximately 45° from the air panel surface. After lifting the air inlet grille keeping it inclined, draw the air inlet grille
forward. (Remove the filament tape (4 portions) fixing the air filter.).
P-AP160NA1
Air inlet grille
Corner pocket cover
(4 portions)
2 Lift the grille keeping it inclined
P-AP160NAE
3 Draw the grille towards the open space after lifting.
N O T E
Perform the attaching work in the reverse procedure of removing for install the air intake grille. The air inlet grille
can be attached from any 4 directions by rotating it. The air intake grille direction can be selected freely.
Installing Air Panel
1 Remove the cover of the corner pocket (4 portions). Remove pulling A part toward the arrow direction.
20
SMGB0077 rev.0 - 01/2013
Indoor unit
+5
12
0
Ceiling surface
Air panel
Knob
A
Supporting string