Honeywell VideoBloX User Manual page 54

VideoBloX MODULES
38
•
Set the "End Address" SW3 (1-8) and SW4 (1-3) to match the address of the last
input card within the connected sub-chassis.
•
SW4 (4-5) are reserved for future use to select protocols.
•
SW4 (6) is used for testing to switch inputs to the outputs, camera 1 to monitor 1,
camera 2 to monitor 2, camera 15 to monitor 15, etc.
•
Turn SW4 (7) to on to enter test mode. In test mode, the module cycles various
inputs to outputs. This is useful for bench-top fault-finding and should not
normally be used in the field.
•
SW4 (8) is not used.