Devices; Peripheral Devices Configuration - Honeywell VideoBloX User Manual

SETFLAG Flag Number
HALTFLAG Flag Number
DO
WHILE Flag Number
IF Flag Number
ELSE
ENDIF
Camera
WHILEBSY number (0 for
auto)
Camera
IFBUSY
number (0 for
auto)
SETMODE PCK Number
Net node /
STARTNET
satellite
Net node /
STOPNET
satellite
Net node /
OP_NET
satellite
Net node /
DEV_NET
satellite
Alarm
GUI_ALM
reference

Devices

Peripheral Devices Configuration

Each device (VCR/DVR, Multiplexer, etc.) connected to the matrix must be defined in the
NETCPU. The Devices Tab is used to configure these peripheral devices.
State (0,1 or 2
to toggle)
State to cause
halt
State for
conditional to
execute
State for
conditional to
execute
Required
Mode
Remote
Sequence
sequence
Parameter
number
Remote
sequence
number
Board number Output State
Remote device Remote device
type address
Optional Alarm
Alarm State
Parameter
Set/Clear/Toggle a system
flag
Halt Sequence on Flag
Set or Flag Cleared
Conditional Repeat
End of Conditional Repeat
Conditional
Condition not met
End of Conditional
Wait while PTZ is in use.
Conditional if PTZ is in
use
Set PCK Mode
Start Remote (net)
sequence
Stop Remote (net)
sequence
Lock state. 1:
Operate Network Output
Lock; 0: unlock
Remote device Operate Networked
key code Device
Generate Alarm on GUI
Honeywell
117