Appendix C: Aux Command List - Honeywell VideoBloX User Manual

APPENDIX C: AUX Command List

7. APPENDIX C: AUX Command List
When SW 1(8) on the NETCPU & NETOSD module is set to 1, COM1 is used for third-
party integration. Refer to the following table for detailed information about the command.
Command
SWITCH
PTZRCL
PTZSTOR
PTZAUX
PTZABS
PTZC
PTZ
148
Instruction Example
Input switch SWITCH 1,1
PTZ recall PTZRCL 6,10
PTZ store PTZSTOR 6,10
PTZ AUX PTZAUX 6,1,1
PTZABS
PTZ position set
6,10,20,20
PTZ control PTZC 6,1,0
Control PTZ
which just acted
PTZ 1,0
by command
SWITCH
Parameter describe
Input number, output number
Address, recall number
Address, store number
Address, AUX key number, AUX key
status
Address, X value, Y value, Z value.
Address, command, parameter
Command :
PTZ Stop
PTZ pan
PTZ tilt
PTZ zoom
PTZ focus
PTZ iris
PTZ combined lens
Parameter:
PTZ Stop : 0
PTZ pan : -127 to 127
PTZ tilt : -53 to 53
PTZ zoom : -1 to 1
PTZ focus : -1 to 1
PTZ iris : -1 to 1
command, parameter
Command :
PTZ Stop
PTZ pan
PTZ tilt
PTZ zoom
PTZ focus
PTZ iris
PTZ combined lens
Parameter:
PTZ Stop : 0
PTZ pan : -127 to 127
PTZ tilt : -53 to 53
PTZ zoom : -1 to 1
PTZ focus : -1 to 1
PTZ iris : -1 to 1
0
1
2
3
4
5
6
0
1
2
3
4
5
6