Honeywell VideoBloX User Manual page 124

SYSTEM CONFIGURATION
Parm1
Parm2
Parm3
Parm4
Comment
DEFINITIONS
Command Description
Parameter 1 Description
Parameter 2 Description
Parameter 3 Description
Parameter 4 Description
COMMANDS
Delete Sequence
Create Sequence
Quit
Save to Flash
Steps for Defining Sequences
1. On the Sequences screen, select the Editor tab on the right side of the window.
2. Select the Sequence Number to be defined. If the sequence is "blank" (not
3. Click
4. Click in the Command cell of the newly created row. The drop-down box will show
5. Review the parameters related to this command and enter appropriate values in the
108
previously defined), the Create Sequence key will be available. Select Create
Sequence. The END command will be the only command included in the sequence.
to add a record to the sequence.
which commands are available. Select the appropriate command.
Parm1, Parm2, Parm3, or Parm4 field(s) necessary. Enter any comments that may
be helpful.
Used to enter an applicable parameters value for this
command (as needed). More detailed information for this
parameter is displayed in the Parameter 1 field below the
sequence table.
Used to enter an applicable parameters value for this
command (as needed). More detailed information for this
parameter is displayed in the Parameter 2 field below the
sequence table.
Used to enter an applicable parameters value for this
command (as needed). More detailed information for this
parameter is displayed in the Parameter 3 field below the
sequence table.
Used to enter an applicable parameters value for this
command (as needed). More detailed information for this
parameter is displayed in the Parameter 4 field below the
sequence table.
Free text field for comments.
Descriptive field for command.
Descriptive field for Parameter 1.
Descriptive field for Parameter 2.
Descriptive field for Parameter 3.
Descriptive field for Parameter 4.
Delete this entire sequence.
Create a new sequence.
Stop all changes.
Saves all sequences which have been downloaded to the
NetCPU to the NetCPU flash memory.