Alarms; Alarm Configuration - Honeywell VideoBloX User Manual

MONITOR NUMBER
Monitor number
Monitor 1-4
Steps for Defining Groups
1. On the Groups screen, select the Group Number to be defined.
2. Enter/edit the Group Name.
3. In the Formatting field, enter the text to be displayed on the keyboard when the
group is selected. %ld will be replaced by the number entered on the keyboard. For
example, if "SCENE %ld" is entered in the Formatting field, the text "SCENE 3" will
be displayed on the keyboard when scene 3 is selected.
4. In the Zero Display field, enter the text to display on the keyboard if a wrong group is
selected.
5. From Available Scenes, click on the scene to add to the group then click
move it to the Selected Scenes. Repeat this step as often as needed to select all
scenes which should be included in this group.
Remove scenes by clicking on the scene in Selected Scenes and clicking
NOTE: Consider the order in which you select/enter and remove scenes.
The camera scenes will display in the order entered.
6. Choose the number of the monitors and specify the monitor number.
7. Select
8. To define additional groups, repeat steps 1-6.

ALARMS

Alarm Configuration

VideoBloX supports the monitoring of alarm inputs, with alarm inputs being any change of
state (COS) contact that has an "on" and "off" state. Common alarm inputs are Door
Status Monitor switches, Motion Detectors, and Duress Alarms. These devices would be
connected to alarm inputs on the VideoBloX system. Such Alarm Inputs would be on the
Alarm Terminal Module provided with every system (32 Alarm Inputs) and on the optional
I2C Alarm Input Modules (16 Alarm Inputs) connected either locally to the VideoBloX
CPU or remotely through data concentrators.
Signal, two or four monitors. When choose signal, system
switch view in scene one by one on the monitor keyboard
activated. Two or four monitors' modes, system switch views
in scene to the monitor user set.
Monitors user set.
to save/download all information from the current page.
Honeywell
to
.
67