Fuse; Connections; Firmware Upgrade - Honeywell VideoBloX User Manual

VideoBloX MODULES
PWR
NETCORE_CPU On when NETCORE for CPU module is inserted
NETCORE_OSD On when NETCORE for OSD module is inserted
BP
COM1
COM2
COM3
10/100M ACT
10/100M LNK

Fuse

The NETCPU module and NETOSD module have 1 PCB mounted fuse separately, rated
at 0.75A. The fuse should only blow in the event of a fault on the board. In such an event,
the NETCPU & NETOSD module should be returned to a Honeywell distributor for repair.

Connections

All serial ports use the following pin-outs:

Firmware Upgrade

Firmware of NETCPU & NETOSD module can be upgraded by internet. Upgrade files
must be copied to local machine before upgrade.
NETCPU Firmware Upgrade
Perform the following steps to upgrade NETCPU firmware.
1. Enter the IP address in the Internet Explore address bar and press Enter. Then the
Login page
14
LED
On when chassis is powered up
Flashes when data transfer is detected on the backplane
Flashes when data transfer is detected on COM1 port
Flashes when data transfer is detected on COM2 port
Flashes when data transfer is detected on COM3 port
Flashes when data transfer is detected on Ethernet port
Flashes when the connection is detected Ethernet port
Pin
1 RS422 TX[+]/RS485[+]
2 RS422 TX[-]/RS485[-]
3
4
5
6
7 RS422 RX[-]
8 RS422 RX[+]
(Figure 2-9) is displayed.
LED Function
Definition
NC
RS232TX
GND
RS232 RX