Chain Case Oil Seal Installation - Honda S2000 Service Manual

Gylinder Head
60.
Cam Chain Installation (cont'dl
Install the alternator-compressor belt.
lnstall the vacuum tank.
tbf.ft)
Install the air cleaner housing/inlake air duct
assembly, then installthe vacuum hoses. Connect
the air control solenoid valve connector (see step
4 3 o n p a g e 6 - 5 2 ) .
I n s t a l l t h e t h r o t t l e c a b l e ( s e e p a g e 1 1 - 1 2 5 ) , t h e n
adjustthe cable (see page 11-124\.
After installation. check that all tubes, hoses and
connectors are installed correctly.
After assembly, wait at least 30 minutes before
f i l l i n g t h e e n g i n e w i t h o i l ( s e e p a g e 8 - 5 ) .
Refill the radiator with engine coolant, and bleed
air from the cooling system with the heater valve
open {see page
'10-8).
Inspect for fuel leaks. Turn ON (ll) the ignition switch
(do not operate the starter) so that the fuel pump
runs for about 2 seconds and pressurizes the fuel
line. Repeat this operation two or three times, then
check for fuel leakage at any point in the fuel line.
I n s p e c t t h e i d l e s p e e d ( s e e p a g e 1 1 - 1 0 0 ) .
I n s p e c t t h e i g n i t i o n t i m i n g ( s e e p a g e 4 - 1 8 ) .
Connect the negative battery cable first, then
connect the positive cable.
Enter the anti-theft code for the radio, then enter
the customer's radio station presets.
62.
6 1 .
6 1 .
7 1 .
64.
65.
66.
69.
1 0 .
72. Reset the clock.
6 x 1 . 0 m m
't2 N.m
{1.2 kgf.m,8.7
6-24
Chain Case Oil Seal Installation
Special Tools Required
. Driver 07749-0010000
. Attachment, 52 x 55 mm 07746-0010400
1. Use the specialtools to drive a new oil seal
squarely into the chain case to the specified
installed height.
07749-0010000
077i16-0010,100
il
2. Measure the distance between the chain case
surface (A) and the oll seal (B).
Oil Seal Installed Height:
34.0-34.7 mm {1.34-1.37 in.)
34.0-34.7 mm
(1.3i1-1.37 in.)