Honda S2000 Service Manual page 840

8. Remove the dashboard {see page 20-82).
9. Remove the blower/evaporator unit
( s e e p a g e 2 1 - 3 8 ) .
10. Remove the mounting bolts, the center brackets (A),
and the audio brackets (B).
8 x 1,25 mm
22 N.m 12.2 kgf.m, 16lbt ft)
l -
6 x 1 , 0 m m
9.8 N.m (1.0 kgf.m,7.2 lbf.ftl
8 x 1.25 mm
2 2 N m
{2.2 kgf.m, 16 lbf.ft}
Remove the SRS unit {see page 23'75),
Remove the self-tapping screws and the defroster
outlet (A), then remove the wire harness clips (Bi.
1 1 .
1 2 .
Disconnect the connectors (A) from the mode
control motor and the air mix control motor, then
remove the wire harness clip {B). Remove the
mounting nuts, the mounting bolt, and the heater
u n i t ( C ) .
6 x 1 . 0 m m
9.8 N.m
{1.0 kgf.m,
7.2 tbf.lrl
6 x 1 . 0 m m
9 . 8 N m
11.0 ksf.m, 7.2lbf.ftl
/
\
4. Remove the self-tapping screw and the passenger's
heater outlet (A), then remove the self-tapping
screw and the clamp (B). Be careful not to bend the
inlet and outlet pipes during the heater core (C)
removal, and oull out the heater core.
B---_
t
___|.+
(cont'd)
rK
M-
21-41