How To Clear Eps Dtcs - Honda S2000 Service Manual

EPS Components
General Troubleshooting Information (cont'dl
4. The blinking frenquency indicates the DTC. DTCS
are indicated by a series of long and short blinks.
Add the long and short blinks together to determine
the DTC. After determining the DTC. refer to the
DTC troubleshooting index,
The system will not indicate the DTC unless these
conditions are met:
. Set the front wheels in the straight ahead driving
position.
. The ignition switch is turned ON (ll).
. The engine is stopped.
' The SCS circuit is shorted to body ground before
the ignition switch is turned ON (ll).
Example ot DTC 12
Short blinks
{two times)
*l
Examolo ot DTC 23
Turn the ignition switch OFF.
Disconnect the Honda PG M Tester from the DLC.
17-20
How to Clear EPS DTCs
Honda PGM Tester Method:
1. With the ignition switch OFF, connect the Honda
PGM Tester (A) to the 16P data link connector (DLC)
{B) located under the dash on the passenger's side
of the vehicle.
Turn the ignition switch ON (ll), and clear the
DTC(S) by following the screen prompts on the
PGM Tester.
NOTE: See the Honda PGM Tester user's manual
for specific instructions.
2
li -
.,/
----==
r
- -tt"=-=,,-.,-
,,
+rri