Honda S2000 Service Manual page 747

Removable Hardtop
Roof Position Adjustment (cont'dl
4. lf the roof alignment is still not within specification, unlock the roof, and repeat the preceding steps.
5. lf the roof alignment is not within specification, check the body side catches, and check for body de{ormation.
6. Lockthe roof (A) securely with both lockhandles(B) and roof side locks (C). Checkthe level difference between
the roof and body (D) at the measuring point LAl .lf the difference is notwithin specification, removethe roof
from the body, and adjust the difference with the spacers (E) that are installed between the lock handle and the
roof,
SPACER:
Thickness= 1 mm 10.04 in.)
Measurlng Point [AJ :
7. Set the roof onto the body, and lock it securely. Check that the weatherstrip fits flush, and check that each door
glass contacts the weatherstrip evenly. lf necessary. adjust the retainer; refer to the roof molding replacement
(see page 20-57).
8. Removethe roof fromthe body, and reinstall the B-pillartrim onthe roof.
9. Set the roof onto the body. and lock it securely. Reconnect the rear window defogger connectors securely.
10. Make sure that the roof is locked securely, then raise the door glass fully, and close the doors.
11. Check for water leaks. Run water over the roof and on the sealing area as shown, and note these items:
. U s e a 1 2 m m ( 1 / 2 i n . ) d i a m e t e r h o s e ( A ) .
. Adjust the rate of water flow (B).
. Do not use a nozzle.
. Hold the hose about 200 mm (7.9 in.) away from the door.
1 2 m m ( 1 / 2 i n . )
*_r*
CI
itY
A
70 mm 12.8 in.l
200 mm (7.9 in.l
20-66