Driveshafts Disassembly - Honda S2000 Service Manual

Driveshafts Disassembly
Special Tools Required
. Threaded adaptet,24x 1.5 mm 07XAC-0010204
. S l i d e h a m m e r , c o m m e r c i a l l y a v a i l a b l e
lnboard Joint Side:
1. Remove the boot bands. Be careful nottodamage
the boot.
. lf the boot band is a double loop type (A), lift up
the band bend (B), and push it into the clip (C).
. lf the boot band is a low profile type (D). pinch
the boot band using a commercially available
boot band pincers (E).
Double Loop Typ€
Low Profile Type
2 . M a k e a m a r k ( A ) o n e a c h r o l l e r ( B ) a n d i n b o a r d j o i n t
(C)to identify the locations of rollers and grooves
in the inboard joint. Then remove the inboard joint
on the shop towel (D). Be careful not to drop the
rollers when separating them from the inboard
i o i n t .
M a k e a m a r k ( A ) o n t h e r o l l e r s ( B ) a n d s p i d e r ( C ) t o
identify the locations of rollers on the spider. then
remove the rollers.
Remove the circlip (D).
Make a mark (E) on the spider and driveshaft to
identify the position of the spider on the shaft.
Remove the spider using a commercially available
bearing remover (F).
(cont'd)
16-5