Roof Front Trim Replacement; Hardtop Lock Handle Replacement - Honda S2000 Service Manual

1 .
Roof Front Trim Replacement
NOTE:
. To remove and install the rooffronttrim. remove the
roof from the body.
' Take care not to scratch the roof.
Scrap off all traces of the old trim, then clean the
roof bonding surface with a sponge dampened in
alcohol. After cleaning. keep oil, grease, and water
from getting on the surface.
Apply primer (3N4 N-200, or equivalent)to the areas
where the roof front trim will be applied.
Apply the roof front trim (A and B):
-1 Peel the adhesive backing (C)from the front
edge of the trim.
-2 Center and fit the trim against the roof.
-3 Apply the trim to the roof while peeling the
remaining adhesive backing (D) from it a little
at a time. Check that the trim is parailel and
free of wrinkles.
-4 Remove the application tape.
Hardtop Lock Handle Replacement
NOTE:
. To remove and installthe hardtop lock handle,
remove the roof from the body.
. Take care not to scratch the headliner.
1 . Remove the hardtop lock handle as shown.
Install the handle in the reverse order of removal,
and note these items:
. Apply multipurpose grease to the springs and the
moving portions.
. Apply liquid thread lock to the thread of the (A)
screw before reinstallation.
Fastener Locations
A > : S c r e w , l B ) : S c r e w , 1
LIOUID THREAD
LOCK
6 m m
2 m m
10.24in.) 10.08 in.l
/D:n:-)
6 x 1 . 0 m m
12 N.m
(1.2 kgt.m,
8.7 rbf.ft)
B
20-61