Snmp V3 User Configuration - NETGEAR GS108T-200NAS Software Administration Manual

Figure 2-16
To configure the trap flags:
1. From the Authentication field, enable or disable activation of authentication failure traps by
selecting the corresponding button. The factory default is Enable.
2. From the Link Up/Down field, enable or disable activation of link status traps by selecting the
corresponding button. The factory default is Enable.
3. From the Spanning Tree field, enable or disable activation of spanning tree traps by selecting
the corresponding button. The factory default is Enable.
4. If you make any changes to this page, click Apply to send the updated configuration to the
switch. Configuration changes take effect immediately.
5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.

SNMP v3 User Configuration

This is the configuration for SNMP v3.
To access this page, click System  SNMP  SNMP V3  User Configuration.
Configuring System Information
GS108T and GS110TP Smart Switch Software Administration Manual
v1.0, April 2010
2-29