Table of Contents
Advertisement
GS108T and GS110TP Smart Switch Software Administration Manual
•
Fast Link. Specifies if the specified port is an Edge Port with the CST. Possible values are
Enable or Disable. The default is Disable.
•
Port State. The Forwarding state of this port. This field is read-only.
•
Path Cost. Set the Path Cost to a new value for the specified port in the common and
internal spanning tree. It takes a value in the range of 1–200000000.
•
Priority. The priority for a particular port within the CST. The port priority is set in
multiples of 16. If you specify a value that is not a multiple of 16, the priority is set to the
priority is automatically set to the next lowest priority that is a multiple of 16. For
example, if you set a value between 0 and 15, the priority is set to 0. If you specify a
number between 16 and 31, the priority is set to 16.
•
External Port Path Cost. Set the External Path Cost to a new value for the specified port
in the spanning tree. It takes a value in the range of 1–200000000.
•
Port ID. The port identifier for the specified port within the CST. It is made up from the
port priority and the interface number of the port.
•
Hello Timer. Specifies the switch Hello time, which indicates the amount of time in
seconds a port waits between configuration messages. The value is fixed at 2 seconds.
6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
7. If you make any configuration changes, click Apply to send the updated configuration to the
switch. Configuration changes take place immediately.
8. Click Refresh to update the information on the screen with the most current data.
3-28
v1.0, April 2010
Configuring Switching Information
Hide quick links:
Advertisement
Table of Contents
