NETGEAR GS108T-200NAS Software Administration Manual page 134

GS108T and GS110TP Smart Switch Software Administration Manual
IGMP Snooping Querier Configuration
Use this page to enable or disable the IGMP Snooping Querier feature, specify the IP address of
the router to perform the querying, and configure the related parameters.
To access this page, click Switching Multicast  IGMP Snooping Querier  IGMP Snooping
 Querier Configuration.
Figure 3-33
To configure IGMP Snooping Querier settings:
1. From the Querier Admin Mode field, enable or disable the administrative mode for IGMP
Snooping Querier.
2. In the Snooping Querier Address field, specify the IP address to be used as source address in
periodic IGMP queries. This address is used when no address is configured on the VLAN on
which the query is being sent.
3. In the IGMP Version field, specify the IGMP protocol version used in periodic IGMP queries.
4. In the Query Interval field, specify the time interval in seconds between periodic queries sent
by the snooping querier. The Query Interval must be a value in the range of 1–1800 seconds.
The default value is 60.
5. In the Querier Expiry Interval field, specify the time interval in seconds after which the last
querier information is removed. The Querier Expiry Interval must be a value in the range of
60–300 seconds. The default value is 60.
3-50
v1.0, April 2010
Configuring Switching Information