Trap Flags - NETGEAR GS108T-200NAS Software Administration Manual

GS108T and GS110TP Smart Switch Software Administration Manual
• Version. The trap version to be used by the receiver from the menu.
• SNMP v1: Uses SNMP v1 to send traps to the receiver.
• SNMP v2: Uses SNMP v2 to send traps to the receiver.
• Community String. The community string for the SNMP trap packet to be sent to the trap
manager. This may be up to 16 characters and is case sensitive.
• Status. Select the receiver's status from the menu:
• Enable: Send traps to the receiver.
• Disable: Do not send traps to the receiver.
2. To modify information about an existing SNMP recipient, select the check box next to the
recipient, change the desired fields, and then click Apply. Configuration changes take effect
immediately.
3. To delete a recipient, select the check box next to the recipient and click Delete.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.

Trap Flags

The pages in the Trap Manager folder allow you to view and configure information about SNMP
traps the system generates.
Use the Trap Flags page to enable or disable traps the switch can send to an SNMP manager. When
the condition identified by an active trap is encountered by the switch, a trap message is sent to any
enabled SNMP Trap Receivers, and a message is written to the trap log.
To access the Trap Flags page, click System  SNMP  SNMP V1/V2  Trap Flags.
2-28
v1.0, April 2010
Configuring System Information