Event Logs - NETGEAR GS108T-200NAS Software Administration Manual

GS108T and GS110TP Smart Switch Software Administration Manual
Table 6-6. Trap Log Statistics (continued)
Field
Trap Log Capacity
Number of Traps
Since Log Last
Viewed
The page also displays information about the traps that were sent.
Table 6-7. Trap Logs
Field
Log
System Up Time
Trap
Click Clear Counters to clear all the counters. This resets all statistics for the trap logs to the
default values.

Event Logs

Use the Event Log page to display the event log, which is used to hold error messages for
catastrophic events. After the event is logged and the updated log is saved in flash memory, the
switch will be reset. The log can hold at least 2,000 entries and is erased when an attempt is made
to add an entry after it is full. The event log is preserved across system resets.
To access the Event Log page, click the Monitoring  Logs tab, and then click the Event Logs
link.
6-22
Description
The maximum number of traps stored in the log. If the number of traps exceeds the
capacity, the entries will overwrite the oldest entries.
The number of traps that have occurred since the traps were last displayed.
Displaying the traps by any method (such as terminal interface display, Web
display, or upload file from switch) will cause this counter to be cleared to 0.
Description
The sequence number of this trap.
The time at which this trap occurred, expressed in days, hours, minutes, and
seconds since the last reboot of the switch.
Information identifying the trap.
v1.0, April 2010
Monitoring the System