Access Rule Configuration - NETGEAR GS108T-200NAS Software Administration Manual

The Profile Summary table shows the rules that are configured for the profile, as the following
table describes.
Table 5-3. Profile Summary Fields
Field
Rule Type
Service Type
Source IP Address
Mask
Priority
Click Refresh to update the page with the most current information.

Access Rule Configuration

Use the Access Rule Configuration page to configure the rules about what systems can access the
GS108T or GS110TP Web interface and what protocols are allowed.
To access the Access Rule Configuration page, click Security  Access, and then click the Access
Control  Access Rule Configuration link.
Managing Device Security
GS108T and GS110TP Smart Switch Software Administration Manual
Description
Identifies the action the rule takes, which is either Permit or Deny.
Displays the type of service to allow or prohibit from accessing the switch
management interface:
• SNMP
• HTTP
• HTTPS
Displays the IP Address of the client that may or may not originate
management traffic.
Displays the subnet mask associated with the IP address.
Displays the priority of the rule. The rules are validated against the incoming
management request in the ascending order of their priorities. If a rule
matches, action is performed and subsequent rules below are ignored.
v1.0, April 2010
5-21