GS108T and GS110TP Smart Switch Software Administration Manual
Figure 7-1
To reboot the switch:
1. Select the check box on the page.
2. Click Apply. The switch resets immediately. The management interface is not available until
the switch completes the boot cycle. After the switch resets, the login screen appears.
Factory Default
Use the Factory Default page to reset the system configuration to the factory default values.
Note: If you reset the switch to the default configuration, the IP address is reset to
192.168.0.239, and the DHCP client is enabled. If you loose network connectivity
after you reset the switch to the factory defaults, see
Network" on page 1-2
7-2
.
v1.0, April 2010
"Connecting the Switch to the
Maintenance