Snmp; Snmpv1/V2 - NETGEAR GS108T-200NAS Software Administration Manual

SNMP

From SNMP link under the System tab, you can configure SNMP settings for SNMP V1/V2 and
SNMPv3.
From the SNMP link, you can access the following pages:
• "SNMPV1/V2" on page 2-25
• "Trap Flags" on page 2-28
• "SNMP v3 User Configuration" on page 2-29

SNMPV1/V2

The pages under the SNMPV1/V2 menu allow you to configure SNMP community information,
traps, and trap flags.
Community Configuration
To display this page, click System  SNMP  SNMP V1/V2  Community Configuration.
By default, two SNMP Communities exist:
• Private, with Read/Write privileges and status set to Enable.
• Public, with Read Only privileges and status set to Enable.
These are well-known communities. Use this page to change the defaults or to add other
communities. Only the communities that you define using this page will have access to the switch
using the SNMPv1 and SNMPv2c protocols. Only those communities with read/write level access
can be used to change the configuration using SNMP.
Use this page when you are using the SNMPv1 and SNMPv2c protocol.
Configuring System Information
GS108T and GS110TP Smart Switch Software Administration Manual
v1.0, April 2010
2-25