Configuring Isdn Pri - Cisco AS5350XM Configuration Manual

Configuring ISDN PRI

Command
Step 7
AS5400(config-controller)# t1 1-28
controller
or
AS5400(config-controller)# t1 1-10,15-20,23
controller
Step 8
AS5400(config-controller)# Ctrl-Z
AS5400#
Verify
To verify that your controller is up and running and no alarms have been reported, enter the show
controller command and specify the controller type, slot, and port numbers:
AS5400# show controller t3 1/0
T3 1/0 is down.
Applique type is Channelized T3
Transmitter is sending remote alarm.
Receiver has loss of signal.
FEAC code received: No code is being received
Framing is M23, Line Code is B3ZS, Clock Source is Line
Data in current interval (330 seconds elapsed):
Total Data (last 24 hours)
If you are having trouble, make sure that the show controller command output is not reporting alarms
Tip
or violations. Also, see the
Configuring ISDN PRI
ISDN PRI interfaces can be configured on the 8-port T1 or E1 feature cards, or the CT3 feature card.
ISDN provides out-of-band signaling using the D channel for signaling and the B channels for user data.
Channelized T1 ISDN PRI offers 23 B channels and 1 D channel. Channelized E1 ISDN PRI offers
30 B channels and 1 D channel. Channel 24 is the D channel for T1, and channel 16 is the D channel for
E1.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
12
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation, 0 P-bit Err Secs
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs
0 Unavailable Secs, 0 Line Errored Secs
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
9944 Line Code Violations, 0 P-bit Coding Violation,
0 C-bit Coding Violation, 0 P-bit Err Secs,
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs,
86400 Unavailable Secs, 0 Line Errored Secs,
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
"Configuring T1 and E1 Feature Cards" section on page
Basic Configuration Using the Command-Line Interface
Purpose
Configures your T1 controllers. Values range from
1 to 28. In this instance, all 28 T1 channels are
configured at once.
or
Omits specified T1 controllers while provisioning
others. In this instance, T1 controllers 11–14, 21,
22, and 24–28 are unprovisioned.
This CLI command is backward
Note
compatible only.
Returns to enable mode.
8.