Cisco AS5350XM Configuration Manual page 39

Understanding Basic Hardware Architecture and Cisco IOS Software
Reload the Cisco AS5350XM or Cisco AS5400XM universal gateway to run the new image. If you
Step 5
erased the old Cisco IOS image, make sure that the boot system flash oldiosname.bin command is not
enabled and pointing to the old image filename; otherwise, the gateway becomes stuck trying to reload
the old image over and over again.
Router# reload
Proceed with reload? [confirm]
System Bootstrap, Version 12.0(20000106:234457) [tombnyg-rommon_1_6 106],
SOFTWARE REV 1.6
Copyright (c) 1994-2000 by cisco Systems, Inc.
AS5400XM platform with 524288 Kbytes of main memory
Self decompressing the image : #################################################
##################################################### [OK]
Self decompressing the image : #################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################### [OK]
Press RETURN to get started!
Note
For more information about TFTP, see the Loading and Maintaining System Images and Microcode
document, available online at
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/fun_c/fcprt2/fcimages.htm
On system reload, if the console session freezes or displays unusual characters on the screen, you may
Tip
have a console session mismatch between the Cisco IOS console line speed and the terminal server
speed. This mismatch may occur because of the program settings of your console or your terminal
server speed.
Before you proceed to correct session mismatch, verify that your problem is not due to a defective cable
Note
or improper cable connection. Check your cable connection or replace the cable and reload the system
again.
To correct a console session mismatch, do one of the following:
Change your console line speed.
•
Change your terminal server speed.
•
If the above two solutions do not correct the console session, install the console jumper on the
•
motherboard to set your default console port speed to 9600 bps.
Most sections of the boot sequence have been omitted from the example.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Upgrading to a New Cisco IOS Release
11