Cisco AS5350XM Configuration Manual page 197

Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when you
Step 6
view the configuration.
Enter enable secret: lab
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Step 7 Enter an enable password. This password is not encrypted (less secure) and can be seen when you view
the configuration.
Enter enable password: guessme
The virtual terminal password is used to protect
access to the router over a network interface.
Enter the virtual terminal password, which is used for remote console access.
Step 8
Enter virtual terminal password: guessagain
Respond to the following prompts as appropriate for your network:
Step 9
Configure SNMP Network Management? [no]: yes
Community string [public]:
Configure IP? [no]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 15
Configure bridging? [no]:
If you answer no to IGRP, you are prompted to configure RIP.
Note
Enter the letter corresponding to the ISDN switch type that matches your telco switch type, or press
Step 10
Enter to accept the default.
Do you want to configure ISDN switch type? [yes]:
The following ISDN switch types are available:
[a] primary-4ess
[b] primary-5ess
[c] primary-dms100
[d] primary-net5
[e] primary-ntt
[f] primary-ts014
Enter the switch type [d]:
Enter yes to allow users to dial in using ISDN or analog modems.
Step 11
Do you intend to allow users to dial in? [yes]: yes
There are 16 controllers on this access server. If you want to use
the full capacity of the access server configure all controllers.
Controller E1 0,1,..etc
on the back of the access server.
PRI configuration can be configured to controllers all at once
based on your PRI controllers selection. Where as CAS configuration
will be configured individually for each controller.
Enter the number of controllers you will be using for the PRI configuration, or press Enter to configure
Step 12
all controllers.
Enter # of controllers, you will be using for PRI configuration [16]:
in software corresponds to Port 0,1,..etc
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Getting Started
13