Cisco AS5350XM Configuration Manual page 194

Universal gateways software configuration guide
Hide thumbs Also See for AS5350XM:
Table of Contents

Advertisement

Getting Started
Configuring controller T1 1/2:
Configuring PRI on this controller.
Configuring controller T1 1/3:
Configuring PRI on this controller.
.
.
.
.
Configuring controller T1 2/6:
Configuring PRI on this controller.
Configuring controller T1 2/7:
Configuring PRI on this controller.
Configuring interface parameters:
Step 14
Enter yes to configure the GigabitEthernet0/0 interface to connect the gateway to a LAN. Then respond
to the remaining questions to configure the Gigabit Ethernet port.
Do you want to configure GigabitEthernet0/0
Use the 100 Base-TX (RJ-45) connector? [yes]:
Note
Operate in full-duplex mode? [no]:
Operate at 100 Mbps speed? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface [X.X.X.X]: 172.22.50.10
Subnet mask for this interface [255.255.0.0] :
Class B network is 172.22.0.0, 16 subnet bits; mask is /16
Step 15
Repeat
Step 16
Configure your serial interfaces by responding to the following prompts:
Do you want to configure Serial0/0
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
Repeat
Step 17
After you complete the configuration script, the setup script displays the configuration command script.
Step 18
Go to the
Cisco AS5350XM or Cisco AS5400XM with AS54-DFC-8CE1
To use the setup script on the gateway configuring two AS54-DFC-8CE1 trunk cards and five
AS54-DFC-108NP universal port cards, take the following steps.
Power up the gateway. The power switch is on the rear panel, at the upper right corner near the power
Step 1
cord, as shown in
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
10
Full-duplex mode enables simultaneous data transfer between a sending and a receiving station.
Step 14
to configure any other Gigabit Ethernet ports, if necessary.
Assign to which interface [GigabitEthernet0/0]:
Step 16
to configure any other serial interfaces, if necessary.
"Save the Configuration File" section on page
Figure
8.
interface? [yes]: yes
interface? [no]: yes
14.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

As5400xm

Table of Contents