Cisco AS5350XM Configuration Manual page 131

Managing and Troubleshooting the Universal Port and Dial-Only Feature Cards
Note
AS5400# copy tftp flash
Address or name of remote host [192.168.19.91]?
Source filename [c5350-js-mz.xm.Feb16]?
Destination filename [c5350-js-mz.xm.Feb16]?
Accessing tftp://192.168.19.91/c5350-js-mz.xm.Feb16...
Loading c5350-js-mz.xm.Feb16 from 192.168.19.91 (via GigabitEthernet0/0):
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[OK - 10573848/21147648 bytes]
10573848 bytes copied in 77.356 secs (137322 bytes/sec)
Verify that the file has been copied into the gateway flash memory:
Step 3
AS5400# show flash
-#- ED --type-- --crc--- -seek-- nlen -length- -----date/time------ name
1 .. unknown 12375B0E 92704 6 337539 Feb 21 2001 22:46:51 np.spe
2 .. image 1A58C7EA AA7F9C 20 10573848 Feb 21 2001 23:11:59 c5350-js-mz.xm.Feb16
5079140 bytes available (10911644 bytes used)
Configure SPEs to Use an Upgraded Firmware File
Follow these steps to configure the SPEs to use the upgraded firmware:
Step 1 Enter the enable command.
AS5400> enable
Step 2 Enter your password.
Password: password
AS5400#
You are in privileged EXEC mode when the prompt changes to
Display SPE firmware versions to obtain the filename of the firmware on flash memory.
Step 3
Note
AS5400# show spe version
IOS-Bundled Default Firmware-Filename
The system no longer asks you if you want to erase flash memory before reloading it. SPE
firmware code is small; unlike system images, you can sometimes hold more than one version
of SPE firmware in flash memory.
If you do not have available space to copy the SPE firmware, during the copy operation the
system displays a message telling you to delete the current file and squeeze the flash memory to
make room for the new image. Enter the delete flash:version command, followed by the squeeze
flash command, to perform this delete-and-squeeze operation. Then proceed with the copy
operation.
As explained previously, the version number and UPG firmware filename may not match until
the upgrade is complete.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Upgrading SPE Firmware
or
AS5350# AS5400#.
Version Firmware-Type
17