Using The Setup Script; Getting Started - Cisco AS5350XM Configuration Manual

Universal gateways software configuration guide
Hide thumbs Also See for AS5350XM:
Table of Contents

Advertisement

Using the Setup Script

This chapter describes how to power up the Cisco AS5350XM and Cisco AS5400XM universal
gateways and configure them using the prompt-driven setup script (also called the System Configuration
dialog).
If you prefer to configure the gateway manually, go to the
page 6
Configuration Using the Command-Line Interface,"
The setup script in this chapter is a typical example using a version of Cisco IOS software that may not
exactly match your newly loaded software; however, message prompts are similar.

Getting Started

Before you power up the gateway and begin to use the setup script in the System Configuration dialog,
make sure you have already connected the cables to the gateway and configured your PC terminal
emulation program for 9600 baud, 8 data bits, no parity, and 2 stop bits. Connect to the gateway through
the console port; the AUX port is not active. All configuration must be performed from your PC terminal
emulation program window.
The prompts and resulting messages vary depending on your responses. For most configurations, you
can press Enter to accept the default entries displayed in square brackets ([]).
This section provides the setup scripts for the following hardware configurations:
Note
Information that you enter is in
configuration, exit and run the System Configuration dialog again by pressing Ctrl-c, and then type
setup at the privileged EXEC (also called enable) mode prompt (
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
to familiarize yourself with the command-line interface (CLI) and then go to
Cisco AS5350XM or Cisco AS5400XM with AS54-DFC-CT3, page 2
Cisco AS5350XM or Cisco AS5400XM with AS54-DFC-8CT1, page 6
Cisco AS5350XM or Cisco AS5400XM with AS54-DFC-8CE1, page 10
for step-by-step instructions.
font. Also note that if you make a mistake during the
boldface
"Exploring Cisco IOS Software" section on
or
AS5350#
AS5400#
Chapter 3, "Basic
).

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

As5400xm

Table of Contents