Cisco AS5350XM Configuration Manual page 188

Getting Started
Enter a hostname for the gateway.
Step 5
Enter host name [Router]: AS5400
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when you
Step 6
view the configuration.
Enter enable secret: lab
Enter an enable password. This password is not encrypted (less secure) and can be seen when you view
Step 7
the configuration.
Enter enable password: guessme
Enter the virtual terminal password, which is used for remote console access.
Step 8
Enter virtual terminal password: guessagain
Respond to the following prompts as appropriate for your network:
Step 9
Configure SNMP Network Management? [no]: yes
Community string [public]:
Configure IP? [no]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 15
Configure bridging? [no]:
Note If you answer no to IGRP, you are prompted to configure RIP.
Step 10 Enter the letter corresponding to the ISDN switch type that matches your telco switch type, or press
Enter to accept the default.
Do you want to configure ISDN switch type? [yes]:
The following ISDN switch types are available:
[a] primary-4ess
[b] primary-5ess
[c] primary-dms100
[d] primary-net5
[e] primary-ntt
[f] primary-ts014
Enter the switch type [b]:
Step 11 Enter yes to create T1 controllers, then enter the number of T1 controllers you want to create, or press
Enter to create all the controllers.
Do you want to create t1 controllers? [yes]: yes
Enter # of t1 controllers, you want to create under t3 controller [28]:
Configuring controller T3 3/0:
Next, you will be prompted to configure controllers.
These controllers enable users to dial in via ISDN or analog modems.
Enter yes to allow users to dial in using ISDN or analog modems.
Step 12
Do you intend to allow users to dial in? [yes]: yes
There are 10 controllers on this access server. If you want to use
the full capacity of the access server configure all controllers.
Controller CT3 0,1...etc
on the back of the access server.
PRI configuration can be configured to controllers all at once
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
4
in software corresponds to Port 0,1...etc